Turning Okuma OSP700L Alarm 128!

[kakashi]

Hi Guys!
I have the issue with this model!
First, i want to take the data to the floppy disk but can not and the screen
Alarm: 128 Memory disk format!
when i searched the OSP alarm & error list book of Okuma, they said: the NC has failed to properly check the control data stored in the mmemory disk. and It also shows me the action!
Action: Replace a new memory board!
but when i took the data again it still alarm!
Many many machine like this before with this alarm, when i change a new memory board, all of them are ok, but this time is not!
Please help me to solve this Problem!
Kakashi!
Thank you!

Similar Threads:

• Okuma Impact 15 with OSP700L will not move in Manual mode
• IS IT POSSIBLE TO RETROFIT THE 1996 OSP700L - LCS15 MODEL OKUMA LATHE....
• Need Help!- Okuma OSP700l 1026 Inverter Bridge Short Circuit
• Need Help!- Okuma OSP700L Alarm Code 1711; Incorrect Tool Number.
• Need Help!- Setting up Tools - OKUMA OSP700L

[aventtini888]

hi how dod you solve this 128 alarm? same problem here if I put switch in instal mode it says no floppy as the machine don't have installed

[bagasajie55]

Hi Guys!
I have the issue with this model!
First, i want to take the data to the floppy disk but can not and the screen
Alarm: 128 Memory disk format!
when i searched the OSP alarm & error list book of Okuma, they said: the NC has failed to properly check the control data stored in the mmemory disk. and It also shows me the action!
Action: Replace a new memory board!
but when i took the data again it still alarm!
Many many machine like this before with this alarm, when i change a new memory board, all of them are ok, but this time is not!
Please help me to solve this Problem!
Kakashi!
Thank you!

Do you have a floppy disk by the machine. Can you send me the file inside the floppy please.

Regards,
Bagas

bagasajie55@gmail.com