Reply with QuoteWhat "setting" would you change? Write a program for boring soft jaws.
how to machine through soft jaw on cadet
Need help to change setting for okuma cadet when machine a through soft jaw.
thanks!
Similar Threads:
- Need Help!- Pacer Cadet
- Free soft from CAD up to CAM soft
- Need Help!- Okuma cadet Mate Machine Time.
- Need Help!- Cadet Mate
What "setting" would you change? Write a program for boring soft jaws.
The beaten path, is exclusively for beaten men.
machine through soft jaw
I have the program, I throught that I need to change the parameter setting somewhere, otherwise the mahine has alarm if I don't clamp something in the jaw.
when it is not a through soft jaw, I can clamp something in the back of jaw, then machine the front.
thanks!
You should be machining the jaws in a clamped state, chucks do wear & clamping a part in jaws machined in clamped state would run more true than those machined in a closed conditionOriginally Posted by a00509265
The chuck closed / clamped sensor is on the other end of the spindle, RED light on means OK to cycle start. This is usually set when holding a part, if chuck is open or if chuck closed ( with not part ) should have no RED light - thus stopping an accidental cycle start
You can do this by changing chuck gripping from OD to ID, but I agree with Superman that you will want a chucking ring to grip on for best results.
Best regards,
In my opinion, set of reverse gripping with reduced pressure is good enough. You need to make a taper - counting deformation of work grip. It's 150µm in diameter per (50 ... 60)mm jaw gripping length. You need to experiment and measure at place for best result
Thanks for help, chucking ring works really good.
Thanks!
Re: how to machine through soft jaw on cadet
does anyone know what the chuck proximity switch check is ? ? does anyone have a okuma crown i am experiencing a similar problem where i can't OD grip
Posting Permissions
