Don't know that machine model, but no. All lathes have a coupling or pin to lock in a turret. It's always a mechanical alignment.
I need help aligning the left turret on the okuma & howa vtl. I have looked at the book I was given by the owner and I'm not sure that it is correct. I am more of a mill man than lathe. The book says to remove bolts and pins from coupling. I was wondering if ut could be done in the parameters using the hand pulse wheel. Please advise of how to do this. It would be greatly appreciated.
Similar Threads:
Don't know that machine model, but no. All lathes have a coupling or pin to lock in a turret. It's always a mechanical alignment.
This model actually has ten 12mm bolts that actually go up into the coupling. I have checked to make sure there are no pins i only have to adjust it .031. But everytime i make the adjustment it goes right back to where it was. Thank you any more advice on which bolts to remove would be greatly appreciated
Hello,
I am desperately in need for the parameters for this machine, PC and PMC or diagnostics. If you could share or sell please let me know
My email address is JOLULA@yahoo.com
Thank you
jolulank
www.doctornumerico.com
cnc physicians