OKK MCV-300 , Meldas 84, parameters

[Nymisis]

hey guys, i'm in a serious bind and i'm hoping someone out there can help. Recently i lost my battery and consequently all my parameters, Now i have a list of all of them, the problem is when i try to set them. after powering up i'll select the "DGN" key then the "ER" key then type TIT "input" then type PASET "input" then select the PA/S key.. now i can edit the "OP" frame but beyond that it wont let me edit further. when i try to edit the "LM" frame or the "BL" frame, after i type in the values and input them it will change the value on the first line to a zero and lock me out of the rest of the frame .. any help would be greatly appreciated.

Similar Threads:

• Need Help!- Misubishi Meldas Lost parameters
• Need Help!- Meldas Leadwell MCV-550 lost parameters
• Need Mitsubishi Meldas 320' parameters for Cincom L16
• Meldas 625m control parameters
• Need help with spindle parameters on Puma 6s with Meldas

[chippy1]

Sometimes after you set the OP parameters you need to power off and on the NC, then try setting the rest of the parameters. After you power back on, check to make sure the OP's are still set. If not, then you may have another problem.


Chippy

[DPL86]

you have to type : TIT (INPUT)
PASET_ (INPUT)

after that , input all the parameter (press ""input"" after each changing...)
shut down the machine , open the machine and you should run whith the new pamameters

so : PASET_ ........(VERY IMPORTANT!...)

[KIMMAO]

Please, give me the parameter meldas 320M