Need Help! Problem with my OKK Millcon III (MHA 400 & MHA 300)

Results 1 to 2 of 2

Thread: Problem with my OKK Millcon III (MHA 400 & MHA 300)

  1. #1
    Registered
    Join Date
    Jun 2017
    Location
    India
    Posts
    3
    Downloads
    0
    Uploads
    0

    Question Problem with my OKK Millcon III (MHA 400 & MHA 300)

    I have two machine of OKK Millcon III (MHA 400 & MHA 300). Both has Meldas 83A controller

    The machine when bought was not in running condition and was idle for a while

    I tried to power up the machinery

    Both displays the same alarm E=20 when i try to power on the machine and release the emergency

    Moreover I tried to change the parameter which wasn't successful at all

    I have been told that it's a software related emergency parameter

    I'm not convinced with the reply

    I'm open to suggestions

    If needed I can send screenshots

    P.S. I have the original parameters. But i would like to know the parameter setting procedure. Because however we do it, we couldn't change the parameters other than the M list

    Kindly assist

    Similar Threads:


  2. #2
    Member
    Join Date
    May 2008
    Location
    Viet Nam
    Posts
    107
    Downloads
    0
    Uploads
    0

    Default Re: Problem with my OKK Millcon III (MHA 400 & MHA 300)

    Dear delicatev4.
    Did you solved this problem? If yes, could you give me the way to fix this( I have MHA300 machine with the same E20 alarm).
    Could you sent me the parameter: namnp2007@gmail.com.
    Thanks for you help.
    Nam.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Problem with my OKK Millcon III (MHA 400 & MHA 300)

Problem with my OKK Millcon III (MHA 400 & MHA 300)