tool display NX7.5

Results 1 to 2 of 2

Thread: tool display NX7.5

  1. #1
    Registered daytonawilli's Avatar
    Join Date
    Mar 2011
    Location
    L?denscheid
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default

    Hello everybody
    I get the following error message when I try to carry out a countersinking operation ‘countersink tool with the flat cone point not allowed’
    The tool is declared and displayed correctly in the tool view- so with a flat cone point!
    What am I doing wrong?

    I hope you understand what I described.

    Regards Dw



  2. #2
    Registered RNB_2000's Avatar
    Join Date
    Jun 2005
    Location
    Genthin
    Posts
    7
    Downloads
    0
    Uploads
    0

    Default

    Hello
    We still have NX6 and it doesn’t work either with that version. It’s best to set the cone point diameter to zero. Then it lifts off a bit too much but it still drives.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

tool display NX7.5

tool display NX7.5

tool display NX7.5