Problem NM200 axes not moving

Results 1 to 4 of 4

Thread: NM200 axes not moving

  1. #1
    Member
    Join Date
    Dec 2009
    Location
    USA
    Posts
    594
    Downloads
    0
    Uploads
    0

    Default NM200 axes not moving

    I went out to start up the mill today, and found that the PP control won't move the axes. Once the mill and PP are started, I can start the spindle, and jogging commands do cause the DROs to advance. I can manually turn the X-axis ball screw. No error messages. I checked all the cable and connections and all are secure. Mill was running fine before last shutdown.

    I thought I'd post here in case there was something obvious to check before I tear covers off the computers.

    If I disconnect the PP computer from the Novakon box and restore the loopback cable, I should be able to still run Mach3 on the CD100. I didn't feel up to that today.

    Similar Threads:


  2. #2
    Community Moderator Jim Dawson's Avatar
    Join Date
    Dec 2013
    Posts
    5717
    Downloads
    0
    Uploads
    0

    Default Re: NM200 axes not moving

    Fuse or breaker on the axis drive power supply?

    Jim Dawson
    Sandy, Oregon, USA


  3. #3
    Member
    Join Date
    Dec 2009
    Location
    USA
    Posts
    594
    Downloads
    0
    Uploads
    0

    Default Re: NM200 axes not moving



    Turns out one of the 3 power cords to the control had become detached. Easy fix.



  4. #4
    Community Moderator Jim Dawson's Avatar
    Join Date
    Dec 2013
    Posts
    5717
    Downloads
    0
    Uploads
    0

    Default Re: NM200 axes not moving



    Jim Dawson
    Sandy, Oregon, USA


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

NM200 axes not moving

NM200 axes not moving