PathPilot 2.2.2 Pulsar

Results 1 to 2 of 2

Thread: PathPilot 2.2.2 Pulsar

  1. #1
    Member
    Join Date
    Jan 2016
    Posts
    291
    Downloads
    0
    Uploads
    0

    Default PathPilot 2.2.2 Pulsar

    I have been using PathPilot 2.0.0 since Brian Posted his files back in December '17 without any issues. Today, I decided to connect the internet to the mill to save running around with the usb drive. Well if you run PathPilot you know you activate the internet in the status tab. There is also a big <<UPDATE>> button right there. So I decided to update to v2.2.2. Copied all the required files to their respective locations and now PathPilot errors out. I poked around for a while but never did figure it out. I reverted back to v2.0.0 and all is fine again.

    Just wondering if any of you running PathPilot 2.x have run into this? Which updates have you applied with without issues?

    Steve

    Similar Threads:


  2. #2
    Member
    Join Date
    Jan 2016
    Posts
    291
    Downloads
    0
    Uploads
    0

    Default Re: PathPilot 2.2.2 Pulsar

    So I went and installed PathPilot's 2.x updates incrementally and found you can safely update to version 2.1.5. PP v2.1.6 is where the the problem starts.So I will stick to version 2.1.5 until I have a chance to review the log file. PP v2.1.6 added support for the door lock switch which might be causing the problem.

    Steve



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

PathPilot 2.2.2 Pulsar

PathPilot 2.2.2 Pulsar

PathPilot 2.2.2 Pulsar