I would think long and hard about the 2oP before buying. They limited the heck out of the control. No macros, tool offsets aren't stored on the machine, small envelope. I was set up to lease one and finally realized after sending sample programs it couldn't run my parts. They want it to ONLY be second op. The controller is practically an Allen Bradley input interface.
On the plus side... They do their own leasing. VERY easy lease. Put a good chunk down but the payments were cheap enough and you re up each year or buy out.
Having run a Haas control for the last couple years I'm hosed. Even my Fanuc control from 1996 have more options and better interface than the 2oP. It's for second op... Only.
Sent from my SM-G935V using Tapatalk