- Milltronics MB 24 Control System
-
Member
Milltronics MB 24 Control System
I am about to remove the entire control system from a Milltronics MB-24 knee mill.
It has the single board computer with the floppy drive emulator from Mr.Bob.
4 Glentek GA-370-3 drive amplifiers,and the Centurion 6 front panel control board are available.
This is a 4 axis setup.
I am keeping the servos,the VFD and the power supply.
Most of the cables will come with it,including servo wiring and encoders.
Machine currently runs with no problems.
Would like to sell as a set.Make offer before it all goes on Ebay.
Either PM here or contact @ skmachineshop@optonline.net.
Thanks
Jeff Catrone
S-K Speed
-
-
Member
Re: Milltronics MB 24 Control System
Sorry for the "double" post.For some reason it will not let me edit from yesterday.
I am about to remove the entire control system from a Milltronics MB-24 knee mill.
It has the single board computer with the floppy drive emulator from Mr.Bob.
4 Glentek GA-370-3 drive amplifiers,and the Centurion 6 front panel control board are available.
This is a 4 axis setup.Software version 6.6404.
I am keeping the servos,the VFD and the power supply.
Most of the cables will come with it,including servo wiring and encoders.
Machine currently runs with no problems.Crystal clear screen.
Would like to sell as a set.Make offer before it all goes on Ebay.
Either PM here or contact @ skmachineshop@optonline.net.
Thanks
Jeff Catrone
S-K Speed
- Milltronics MB 24 Control System
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules