Milltronics MB 24 Control System

Results 1 to 1 of 1

Thread: Milltronics MB 24 Control System

  1. #1

    Default Milltronics MB 24 Control System

    I am about to remove the entire control system from a Milltronics MB-24 knee mill.
    It has the single board computer with the floppy drive emulator from Mr.Bob.
    4 Glentek GA-370-3 drive amplifiers,and the Centurion 6 front panel control board are available.
    This is a 4 axis setup.
    I am keeping the servos,the VFD and the power supply.
    Most of the cables will come with it,including servo wiring and encoders.
    Machine currently runs with no problems.
    Would like to sell as a set.Make offer before it all goes on Ebay.

    Either PM here or contact @ skmachineshop@optonline.net.

    Thanks
    Jeff Catrone
    S-K Speed

    Attached Thumbnails Attached Thumbnails Milltronics MB 24 Control System-20210710_135025-jpg   Milltronics MB 24 Control System-20210710_135047-jpg  


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Milltronics MB 24 Control System

Milltronics MB 24 Control System

Milltronics MB 24 Control System