Bridgeport R2E4 Boss 10 Series II Parts

Results 1 to 1 of 1

Thread: Bridgeport R2E4 Boss 10 Series II Parts

  1. #1
    Member
    Join Date
    Dec 2016
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Bridgeport R2E4 Boss 10 Series II Parts

    I retrofitted my mill to Linux and I have all the old parts leftover from the original machine. There was a problem with the driver boards which would cause an intermittent fault, I'm not sure what the issue was since I never tried to diagnose it. Other than that the machine ran fine, and had very low hours. I'm not posting prices because I don't want much for any of it, I'd rather not give the parts away, but I'd also rather not throw them away.

    Bridgeport R2E4 Boss 10 Series II Parts-r2e4-parts-jpg

    The screen and control board was replaced by the previous owner and only has a few hours of use on it. I have the stock encoders as well.

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Bridgeport R2E4 Boss 10 Series II Parts-r2e4-parts-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Bridgeport R2E4 Boss 10 Series II Parts

Bridgeport R2E4 Boss 10 Series II Parts

Bridgeport R2E4 Boss 10 Series II Parts