Bridgeport R2E4 Boss 10 Series II Parts
I retrofitted my mill to Linux and I have all the old parts leftover from the original machine. There was a problem with the driver boards which would cause an intermittent fault, I'm not sure what the issue was since I never tried to diagnose it. Other than that the machine ran fine, and had very low hours. I'm not posting prices because I don't want much for any of it, I'd rather not give the parts away, but I'd also rather not throw them away.
The screen and control board was replaced by the previous owner and only has a few hours of use on it. I have the stock encoders as well.
Similar Threads:
Reply with Quote
