- multicam 3000 - new Z-axis stepper board, now won't find tool changer
-
Member
multicam 3000 - new Z-axis stepper board, now won't find tool changer
Stepper control board arc'd & died, easy replacement with a PacSci 6410-001-n-n-n as I've done in the past BUT now that i've installed a new one, the z-axis stops about 4 inches short of the toolchanger.
I've restarted & rehomed the machine multiple times now and nothing changes except the board gets HOT.
full disclosure, I bought two used stepper boards from a decommissioned machine that were tested BUT now that I open the 2nd package I notice a "calibrated sticker" on the PacSci label. Not certain what path I need to go down here, and a NEW stepper board is weeks away, but is there a way to muck with these to restore to default factory settings? I'd hate to muck with the machine's parameters to accomodate.
Similar Threads:
-
-
Member
Re: multicam 3000 - new Z-axis stepper board, now won't find tool changer
quick follow-up on resolution... major brainfart
I originally mirror'd the dip switch to the existing/failed board, BUT I didn't notice the adjacent pin jumps weren't set to multicam's design.
whew. glad I noticed before I burned up another board or crashed my spindle!
- multicam 3000 - new Z-axis stepper board, now won't find tool changer
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules