MultiCAM-MT510

[MultiCAM-MT510]

The lifting cable (front right) is broken.
Most likely wear and tear.
It was decided to replace not only this cable, but also the left one.
The central one was not changed.
The replacement procedure was not easy.
There were many unsuccessful attempts.
Finally, the left cable was replaced.
With two cables they began to check the machine.

After turning on the machine and starting Find Home, when the table moves along X at the very end, there is a sharp knock and stop
System Interupt: X Home

I ask for help.

Similar Threads:

• Need Help with MultiCAM
• Need help with Multicam 44 Plus
• Multicam HELP? 3000 motor fault Multicam motor fault (0x 4
• Multicam CSG
• Multicam MG

[MCPservice]

Lifting Cable....you might want to upload some picture on the site here to give better idea of what you are talking about