- Need Help!- Multicam 5000 Motor Faults
-
Registered
Multicam 5000 Motor Faults
Hey Guys,
I am currently running a Multicam 5000 CNC, and keep having issues with a Motor Fault.
The CNC runs for about 5 mins, doing several programmed passes, then stops. Then "Motor Fault 16 XB Blink Count 9 Communication Signal" is displayed on the controller.
Anyone ever dealt with this issue?
I have tried, switching out the motor, also tried a reboot through the service menu on the controller. Still no luck.
Please let me know, if you have any insight! Thanks
Similar Threads:
-
-
Member
Re: Multicam 5000 Motor Faults
Most likely you have a break in the encoder cable, and it could be something noticeable or something internal to the cable itself and when you hit a certain spot on the machine comms fail. You will have to replace the cable, and since you are replacing the XB cable, I would advise you replace all ....remember they have ran same number of times back and forth. There is a way to test but you can only do it, it you have a 2521 or newer control board (blue color control board)
If you do have that control board, let us know....
- Need Help!- Multicam 5000 Motor Faults
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules