- Mori MV-JR Power down during ATC error - Please help!
-
Registered
Mori MV-JR Power down during ATC error - Please help!
Hi all,
Similar to mshopsteve's post I have a MV-JR stuck in the midst of an ATC tool change during power down, so the machine just boots to that error (#35).
Until I can get this figured out, can anyone help me bypass this? Can I jumper something, or are there some M-codes to reset it? I really need to get this machine running now, and can afford to go back and fix things properly at a later date. Even doing manual tool changes right now would let me get some jobs out the door, if only I could get past this alarm.
Please help if you can!
Best Regards,
Damian
Similar Threads:
-
-
Member
MV JR ATC
Check other post For MVjr. It is not something you can bypass. Well you can, but its really not to hard to fix the problem. Try that first.
-
Member
[QUOTE=dddamian;668130]Hi all,
Similar to mshopsteve's post I have a MV-JR stuck in the midst of an ATC tool change during power down, so the machine just boots to that error (#35).
Until I can get this figured out, can anyone help me bypass this? Can I jumper something, or are there some M-codes to reset it? I really need to get this machine running now, and can afford to go back and fix things properly at a later date. Even doing manual tool changes right now would let me get some jobs out the door, if only I could get past this alarm.
Please help if you can!
Best Regards,
mek machie to MDI "M31;"inset M35;insert START, sty pushing "+X"
after go to keepl K8.0 mek it to 0
to finish "M32"
restart machine
its all
-
Registered
Thanks lmostafa - keeprl 8 is the key. As long as it's latched in there is little you can do with the machine....
-
Member
pleas in need a hand book for fanuc OM OT maintenace book;connecting book.
if you have hit send by email : lmostafa@hotmail.fr
thaks
-
Member
please i need help i want have a document maitenace for fanuc OT;OM .
if a man have hit send mi by email:lmostafa@hotmail.fr
-
*Registered User*
Re: Mori MV-JR Power down during ATC error - Please help!
Need some help
I have a Mori Seiki MV-80
Tool change command was send when z axis wasn’t home.
Now I’m stuck with the pocket down.
Any help how to get the pocket back in place?
-
Member
Re: Mori MV-JR Power down during ATC error - Please help!
hello, Good morning, i'm searching the manuals of this machine, do you have them and could you share them with me, please?
- Mori MV-JR Power down during ATC error - Please help!
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules