Need Help! EX 451 Spindle alarm unit.


Results 1 to 1 of 1

Thread: EX 451 Spindle alarm unit.

  1. #1
    Member
    Join Date
    May 2014
    Posts
    174
    Downloads
    0
    Uploads
    0

    Default EX 451 Spindle alarm unit.

    Greetings to you all.

    We are getting this EX451 alarm in our recently acquired MV40 MORI SEIKI mill. Spindle will not complete the orientation command and will give us the alarm. Spindle will also fail to obey seed command from MDI mode. It will turn for a few seconds (same as it does with M19) and will coast to stop generating the EX451 alarm. We suspect the magnetic pickup little pcb that is mounted right next to the spindle rotor. We do not have a ways to test this pickup sensor, so we are trying to get a spare but we have no ways to contact a MS supplier since we are in south America. Any information or contact number will be very well appreciated.
    Flex

    EX 451 Spindle alarm unit.-img_20220416_152556-jpg

    Similar Threads:
    Attached Thumbnails Attached Thumbnails EX 451 Spindle alarm unit.-img_20220416_152556-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

EX 451 Spindle alarm unit.

EX 451 Spindle alarm unit.