Problem mori nv5000 bleeding charge tank


Results 1 to 2 of 2

Thread: mori nv5000 bleeding charge tank

  1. #1
    Member
    Join Date
    Apr 2013
    Location
    USA
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default mori nv5000 bleeding charge tank

    I am having trouble getting my knock out cylinder to extend all the way down so I can insert the retention knob in to the fingers of the drawbar. I have been bleeding the charge tank half the day. It only needs to go down another 1/8 inch. We just changed the Bellville washers and fingers. Has anyone seen this problem before? Do I just keep bleeding and adding oil some more?
    Thanks Mercman

    Similar Threads:


  2. #2
    Member
    Join Date
    Feb 2009
    Location
    usa
    Posts
    6023
    Downloads
    0
    Uploads
    0

    Default Re: mori nv5000 bleeding charge tank

    Yes. MDI mode-open bleeder, close bleeder, manual mode, tool unclamp/clamp a bunch of times, rinse and repeat. Now, if the Lucifer valve is failing/failed, all bets are off. Did you replace O-rings? Lots of grease? Was the drawbar shaft scored? Mori springs or aftermarket like Key Bellville? Aftermarket ones usually need to be deburred on the inside.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

mori nv5000 bleeding charge tank

mori nv5000 bleeding charge tank

mori nv5000 bleeding charge tank