Originally Posted by
generaldisarray
ok
dont forget pos on extreme right is bit zero
extreme left is bit seven
make sure PC PARAM 3002.7 has been set to 1. allows M80 ATC cycle stepping (you said you did this so it should be set to 1)
dont forget PWE
PC PARAM 3005 and 3006 will tell you state of ATC if you cant tell visually
if it is not complete use the M codes to make it so.
You cant MDI the M codes if PWE is on
when it is complete
set PC PARAM 3004 and 3008 to zero, must enable PWE.(3004 being zero is what says the cycle is complete)
disable PWE
error light should be gone
make sure pc param n4000s are correct (these are your spindle and magazine pot tool numbers)
I always leave 3002.7 set to 1. I see no need to change it back. My 3002 looks like 11001001 if you dont have it written down
bit 0 is for 1=20 tool magazine 0=24
1 is na
2 is na
3 is orient and pot down during Z home motion =1 (no description for 0)
4 is na
5 is wait for mag index at m30=0 m30 stops magazine=1
6 is large and small tool detection is done =1
7 is M80 thru M89 ATC stepping allowed =1