Greetings everyone.
New member here.

Doing some search and need assistance.

I have a NTX2000 Mill-Turn.
The lower turret is not what I would consider rigid.
I can place an indicator in the top of the turrent and with hand pressure, move that turret in all directions up to +/- 0.002".
I've been told this is OK by the local DMG service group.

I've asked what the factory specs are for this and was told that it doesn't exist.

Anyone have this same CNC and can you move your turret that much?
I have Mazak lathes and those turrets are rigid to 0.0005" with hand pressure.