Mori Seiki Tool Life Alarm

[koolaidkid]

We have 2 Mori Seiki ZL-25s with the MSC-516 control. We are using the tool life management on these machines. The problem is that one of the machines does not stop the machine from running once the tool life is used up. On the machine that works the way we want it to, the machine will not cycle again until the tool life is reset on the offending tool. On the machine that does not work the way we want it to, we get a message on the display that says the tool is used up, but if the operator doesn't pay attention, they can hit cycle start and the message goes away and the machine will keep running. Is there a setting somewhere that I am missing to prohibit the next cycle?

Thanks

Mark

Similar Threads:

• Mori Seiki SH50 alarm 414 Servo Alarm
• Problem- MORI SEIKI SL-25 LUBE ALARM
• Need Help!- Mori Seiki SL3 spindle alarm
• MORI SEIKI CL-20 ALARM!!!

[Bethk]

There may be a parameter setting for tool life management. You can check the 2 ND machine and verify the parameters are set the same in both.