Meldas 500 won't execute G81,G83, canned drill cycle etc.
I have a OKK hm40 that would not execute any drill cycle.
If program line show G98 G81 Z R F it would not execute, I doesn't alarm or have any message, spindle would spin and coolant but will not execute or move to next line. If I do G98 G81 X Y Z R F, then it would execute but would not move to next hole. It would not move to new line but stay at the same line, just stuck or froze basically. The machine seem to recognized the G code. It weird, I have never had this problem before. I have another Okk with meldas 300 and it never have this problem. Same code same program peck and drill just fine. Am I missing something in the control or parameter?
Reply with Quote
Meldas 500 won't execute G81,G83, canned drill cycle etc.
