Need Help! toolchange issues


Results 1 to 1 of 1

Thread: toolchange issues

  1. #1
    *Registered User* novaman's Avatar
    Join Date
    Dec 2018
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default toolchange issues

    Hi
    We recently purchased a used mitsubishi mv5b with a meldas 520 control.
    On startup the control says tool 0 in spindle no matter what tool is actually in there. the other issue is tool changes, I call up a tool and the carousel doesn't move just changes what's there, after the tool change the carousel moves.
    Any help would be appreciated.

    Similar Threads:


  2. #2
    evileye's Avatar
    Join Date
    Aug 2019
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default

    Take all physicsel tools. And call some active tool number. now, give a tool to called tool number. And call another active tool. Now, your physcical tool in the Atc. Press jog and go to the behind the machine. What you see? A atc set buttons and small door. Now you do nc switch of. and open the door, press mag. index button. When the physically installed tool comes to you, enter the number and hold down the set key. Now you set that tool.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

toolchange issues

toolchange issues