DNC problem with milltronics centurion 6

[gmenzies]

Hello

we can RS232 load programs through cimco into memory no problem.

when we try to dnc larger programs. the mill will run for a while , then watching the verify the tool path will go past what appears to be the buffer.
Its almost as the control cannot take more information and the program errors out.
looking at the screen error 501 illegal address. the block only has a few numbers, it has the y value but x is missing

is this a control problem or a cable problem

any help will be greatly appreciated

Gord

Similar Threads:

• Milltronics ml 15 by 40 centurion 7 control
• Milltronics Centurion IV DNC?
• Problem with a Milltronics VKM3 Centurion 6
• Need Help!- Milltronics Centurion 1: DNC from floppy emulator is very sluggish
• Milltronics Centurion Six

[machinehop5]

...most likely the cable if, randomly crashes in DNC.

#1 causes are USB to Serial converters and/or unshielded RS232 cables.