Centurion 6 boot up shell

Results 1 to 3 of 3

Thread: Centurion 6 boot up shell

  1. #1
    Member
    Join Date
    Feb 2006
    Location
    Canada
    Posts
    123
    Downloads
    0
    Uploads
    0

    Default Centurion 6 boot up shell

    How do i get to the shell in dos with 6 control, on the 5 it says hit F1 and on the older control it's Ctr alt delete, F1 doesn't work and i don't wan't to try the ctr alt delete in case it buggers it up, want to see the path and try and get the ballscrew pitch comp working.

    Similar Threads:


  2. #2
    Member
    Join Date
    Sep 2010
    Location
    Phoenix, AZ USA
    Posts
    465
    Downloads
    0
    Uploads
    0

    Default Re: Centurion 6 boot up shell

    I know on the Centurion 5 you do Main-Parms-Setup, then enter Proto3 and then 3, and from there I can't remember, but somewhere it will pop up with exit to DOS. I was just up at my son's last weekend and we did it a lot of times.

    p.s. I'll ask Chris tonight when he's off work, he was the one doing it I was just watching.



  3. #3
    Member
    Join Date
    Jun 2010
    Location
    United States
    Posts
    118
    Downloads
    2
    Uploads
    0

    Default Re: Centurion 6 boot up shell

    This from C6 programing manual page 158

    Get to proteacted mode then

    F9 (Shell) Main-Run-Displ-Shell
    F9 (Shell) is available if the control is in access level 2 or greater. It will Shell out to DOS. To return to the CNC, type exit. F9 (Shell) comes up in protected modes only.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Centurion 6 boot up shell

Centurion 6 boot up shell

Centurion 6 boot up shell