Start sindle with contol panel buttons - is there a parameter that controls this?

[jj83001]

I have a VKM3 mill with the Centurion 7 control. I can issue a speed and run ( S and M3 or M4) command via MDI to start the spindle and I can stop it via the control panel STOP button, but I cannot restart the spindle by pushing either the CW or CCW buttons. Looking at the diagnostic page for the control panel, I can see the control recognizes the button push, but it does not start in either direction. Seems odd that the buttons are there, but don't function.

Is there a parameter setting that will allow this? It would be a lot more handy to restart the spindle with the buttons rather than the multiple steps via MDI. Of course, I would still have to issue an initial speed command, but the ability to turn on/off the spindle via the buttons would be preferable.

Any help is appreciated.

Jim

Similar Threads:

• Centurion 6 Control, Panel buttons not working.
• 4 buttons not working on control panel
• Source for buttons on custom control panel
• Need Help!- buttons on osp 7000l panel
• Machining a contol panel.

[machinehop5]

try "JOG" mode

[jj83001]

Thanks for the suggestion, but the buttons don't work in JOG or RUN mode either, but the STOP button does.

I should mention the control has the SLS software. I'm not sure if it makes a difference, but I would think a simple toolroom mill should have an easier way to start/stop the spindle.

I noticed there is a byte parameter (PB046) that is associated with the front panel spindle control. My machine has 0 for this parameter. Not sure if changing it changes the buttons.

[machinehop5]

one more quick thought...try Holding the Shift Key and pressing CW or CCW or might be some other two key comb for safety

[jj83001]

one more quick thought...try Holding the Shift Key and pressing CW or CCW or might be some other two key comb for safety

Gave it a whirl...still no go

[MortyNTenon]

Alt F3 on a keyboard works on my C6 SLS. Not sure what your 'missing'