Need Help! Centurion IV Ramill VI DNC Help

Results 1 to 2 of 2

Thread: Centurion IV Ramill VI DNC Help

  1. #1
    Registered FB725's Avatar
    Join Date
    Jul 2018
    Posts
    0
    Downloads
    0
    Uploads
    0

    Default Centurion IV Ramill VI DNC Help

    Hi I’ve recently bought a autolink box to DNC drip feed to my Ramill 6 knee mill with a centurion 4 controller and I am having a buffer overload issue. For some reason the autolink is not sending an Xoff signal to the pc so the pc will continue to send the program and starts deleting parts of the program after reaching 60,000kb. I’m hoping someone on here may have some experience with these autolink units any information would be much appreciated. The autolink did not come with any cables but it did come with a manual so I used that to make the two necessary cables and the power cable. I am connected to the pc with a standard null modem db25 to db9 cable I’ve tried turning off the fifo buffer on my pc and even adding 100-1000 ms delay but nothing seems to work if I slow it down to much the machine lags waiting for code from the pc to fast it deletes it.

    Similar Threads:


  2. #2
    Member
    Join Date
    Jul 2010
    Location
    USA
    Posts
    508
    Downloads
    0
    Uploads
    0

    Default Re: Centurion IV Ramill VI DNC Help

    The RS-23 in the C4 control is OLD, OLD school. I will assume that you are running a Win 7 / Win 10 PC. Not sure what DNC software you are running. but there is a setting for "FIFO" buffers, ( First In First Out" Turn this off. and try it.
    Sportybob



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Centurion IV Ramill VI DNC Help

Centurion IV Ramill VI DNC Help