- Replacing X Cable Questions
-
Member
Replacing X Cable Questions
Not sure which color wire goes into which pin location at the x axis cable. The connector has only red and black wires. And they are only numbered one through four. Whereas the DC Servo motor is colored, and also numbered. Similar to the new cable, but not axactly the saem colors for all 8 wires. I'm hoping the numbers are identical and I will match them that way.
Similar Threads:
-
-
Member
-
Member
-
Member
Re: Replacing X Cable Questions
No, but thank you for those. However I do have them already. Unfortunetly they do not tell me where the pin wires go into the connecter.
-
Member
Re: Replacing X Cable Questions
The first pic shows the pin numbers for the encoder wires, 1-12. The other 4 wires go to the servo drive
Sent from my SM-N960U using Tapatalk
-
-
Member
-
Member
-
Member
Re: Replacing X Cable Questions
On my knee mill they go into the round connector then to the contractor, then to the servo drive.
Sent from my SM-N960U using Tapatalk
-
Member
Re: Replacing X Cable Questions
after looking at the schematics. I got it all together. i just get very paranoid when it comes to wiring things. It's not really in my wheelhouse.
All wires are connected and cable is installed! Just have to put a few things back together and see if this solved my issue!
-
Member
Re: Replacing X Cable Questions
Hi Sen2, You should have called me. ( you still can ;-)) I offer a better cable that I designed and speced out., shielded braid on tach, encoder and an overall shield. comes with instructions and tech support for about $200 less then Milltro. look at the motor end of the cable, see that black heat shrink, that will open up and allow coolant to work thru. My cable I use double wall adhesive lined marine heat shrink. see how stiff your old cable is. My cable will not ever do that.
have encoder kits as well.
sportybob
-
Member
Re: Replacing X Cable Questions
Hey Bob. I do have your cable and it is now fully installed. The instructions were very clear once I took a good look. More or less, 8 was just nervous about the removal and install of the cable. Which led my to space out a little when looking at the provided schematics.
- Replacing X Cable Questions
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules