- Need Help!- Mikini 1610L User Manual and XML
-
Member
Mikini 1610L User Manual and XML
Hi everyone! I'm new here and i'm newish to CNC's. I just picked up a used Mikini 1610L and I was wondering if anyone might have a user manual or the original XML file for Mach 3 that they might be able to share.
The Mikini works fine in manual mode but anytime I try to switch to CNC mode, i get a Computer Not Ready error. I'd like to see if i can get this up and running as is before going the retrofit route.
Thanks in advance!
Greg
Similar Threads:
-
-
Member
Re: Mikini 1610L User Manual and XML
Sure man, I'll get you the xml soon. The user manual is pretty worthless but I'll see what I can do.
-
-
Member
Re: Mikini 1610L User Manual and XML
Hi SWATH,
thanks so much for the file! Got the Mikini communicating with Mach3 and the 3 axis running but i can't get the spindle running properly. The spindle works fine in manual mode but when i switch to Mach 3 and turn it on, it will set a speed of 200 and run - if i try to adjust the speed, it shuts off and gives me a message saying PWM set to minimum frequency.
From what i gather, the spindle is a pain point with the Mikini....is this one of those issues?
Thanks again for the help!!
-
Member
Re: Mikini 1610L User Manual and XML
Great I'm glad you got it communicating. I'm not sure specifically how to help with the spindle issue. I think 200rpm was too low for the motor to go. As I recall the minimum PWM signal coming off of the Mikini BOB is like 10hz, which for me was like around 300-400rpm. My current setup is quite different so I'm not sure if it will help since I'm using an ESS, a REX84 spindle converter card, a PMDX-106 spindle card, a VFD, and an AC motor. The original Mikini spindle motor and driver were scabby as hell. In retrospect I would source and replace it all with a 2.2kw(3hp)-3.7kw(5hp) AC servo system.
-
Member
-
Member
- Need Help!- Mikini 1610L User Manual and XML
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules