- Manual plus v360
-
Member
Manual plus v360
Hi
We have bought a dmt kern cd 650 maybe its 1997?? but They didnt send manual...
? had know anything about lathes but i set it up take a little help from DMT at bios settings now i can open it set it up to ref points i tried einlern menus and learn most of them but programm always same i cant find the place to enter a New program .i enter DIN E?NGABE anwahl N7001 but its too hard to write all steps with g0 g1 .is this machine contact with a computer or has it have a program manual or something ...it has a NC data drive near it with D?SKETTE. Do i have to load NC codes with D?SKETTE but how ?
I need really someone to help me show me the ways and tips
-
- Manual plus v360
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules