Maztrol T1- discontinuous run a cycle

[mnikbakht7105]

Hello
I have a Mazak with Maztrol T1 controller. When run a BAR cycle with some line or arc, Tool wait for approximately 1s between two part of a cycle in finish turning. that to lead a line on this part. Which parameter most be chenged that run finish turning continuously?
Thank you
MNik

Similar Threads:

• Problem- Incomplete slot with MGV milling on Maztrol T Plus control
• Need Help!- vtc 20 b maztrol m plus 212 alarm ATC
• Problem- Maztrol - CNCNet program transfer?
• Problem- Maztrol M32 - No monitor display No drive light
• Saving maztrol programs back to computer ?