How to transfer data using RS232 step by step in mitsubishi meldas 500?

[godzila]

Dear all,

I'm new member here.
I ussualy using fanuc controller, and I have problem with old machine (no manual book), mitsubishi machining center using meldas 500. But don't know step by step transfer NCdata, or using tape mode. Please help...

Thanks all

Similar Threads:

• Meldas 520M rs-232 DNC data transfer issues
• mitsubishi meldas 320m rs232 help
• Need Help!- Step/Direction pins should be Step FWD and Step BACK
• Mitsubishi Meldas 520 AMR RS232 Cable pinout??
• Step & direction v Rs232?

[godzila]

dear all

please need the config of PC side, and machine side.
also the RS232 config. Is same config with Fanuc cable RS232 ussualy I use?

Thanks before

[botha.y]

Give me your email and I can send you a document for 500M series.

Cheers.

[gm3211]

The Fanuc cable will work on the Mitsubishi 500 series control. The trick is to set the Device correctly and then the specific Input/Output parameters. The NC running, data in/out should all be the same to eliminate possible issues. There are so many parameters here that can be mis-configured.

Feel free to give me a call or shoot me an email and we can try to work on it together.

[mansour]

dear all
we hvae deep hole drilling from ixion mitsubishi control thier is error ABS 1001 07
i need help

Thanks
mansour

[o_krah]

i need a stepby step too, need help, sent email to me with steps: hibandx@gmail.com thanks

[anthoo_odin]

[Quote = botha.y; 1112756] Dame tu correo electrónico y te puedo enviar un documento de la serie 500M.

¡Salud. [/ Quote]


¿Puede usted al igual que mi pase por favor !!!!!!

[lalocompras]

Hola buenas tardes

me lopodrias enviar a mi tambien porfavor.

lalocompras@gmail.com

[ZOKIPOKI]

do you have expirience with 300 series i wnt to transfer parameters and tool offset
zoki_zv@yahoo.com