mastercam 9, USE ENTRY POINT

[CApostman]

mastercam 9, USE ENTRY POINT, in lead in lead out. I want to force the tool to enter the work at a designated spot to contour. I have not had any success. Please tell me how to accomplish this. I have been using the arcs and lines, but that is not very efficient.

Similar Threads:

• Need Help!- Controlling the entry/start point of a toolpath
• Can I choice the entry point?
• Need Help!- 5 axis entry point
• How to pick entry point
• Entry Point in Contouring

[dpark1]

Create a point where you want to enter,then on toolpath,chain pick the point first,then the contour.Then on your tool paramaters goto your lead in lead out page enter 0 on everything then check the use entry point box.