Mastercam 2022 2d dynamic mill on mach3

[Chmfhm]

Hi

I have peoblem milling via 2d dynamic milling.

I create toolpath for 2d dynamic mill while selecting default mach3 3 axis mill machine and it simulates well in mastercam then i generate nc file. After that i load that file in mach3 it shows on display strangely and goes out from table display

I haven't that problem in 2d countour it works and post correctly

Sending you pics in table display mood of mach3

Can someone tell me what is the problem

Similar Threads:

• How to get a Mach3 post proc. for Mastercam 2022 ??
• Mach3 post Processor for MasterCam 2022.... if existing ?
• News SAVE THE DATE - SolidCAM World 2022 Virtual Summit - May 11, 2022!
• News SAVE THE DATE - SolidCAM World 2022 Virtual Summit - May 11, 2022!
• MASTERCAM DYNAMIC MILLING VID

[warrenb]

Probably just the way the Mach3 controller is displaying I and J locations somewhere off the table. This is used for the math of the toolpath but not used for the actual toolpath. Can you send a sample of the G code. I can run it through my simulator.

[joeavaerage]

Hi,
Mach3 uses incremental arc notation whereas you post is using absolute arc notation. Change the setting in the post and it will work fine.

Craig