Lines on Part

[platonas1]

Hello all,
I am trying to machine a half cylinder but as you can see in pictures the result is not smooth, there some lines on the part (marble), I tried various toolpaths and using 4.5 mm of endmill.

Any ideas please?

Similar Threads:

• Vertical lines in finished part
• Problem- Skinning and Facet Lines (section lines or what ever you want to call them).
• Newbie- Engraving Text with Repimeter Lines (Edge Lines)
• Dashed Lines?? Sames lines to still show dashed in different scaled viewports?
• Need Help hooking up Viper200 Stop-Out lines to CNC4PC C1 BOB Input Lines

[routalot]

Try changing the cut direction so that it goes across the job.

[Superman]

try using surfacing strategy..."Flowline" allows to define a cusp height, even better if you also use a bull or ball mill... I suggest a bull ie 5mm cutter with R2 corners.
ballnose cutters are not running at correct speeds when cutting at the tooltip ( zero diameter )

surface contour will always give steps...

plus.... do not rely on backplot or simulation to show actual finished part... it is so dependant on PC specs & screen scale it not funny. A lot comes down to trial & error ( read this as experience )