Hey guys, im running a router with the joyous Precix controller, that doesn't recognize canned drilling cycles from Mastercam.
The Precix controller ignores the retract height. it drilled my holes and then rapid move to next position. as you can imagine i was super stoked!

is there a way to just use long form code for a simple drilling cycle? how do i turn canned cycles off?

im using the drilling routine to touch off safe screw locations on multiple parts on a sheet of plywood.
i normally use points to create myself a location on each part, then use the drilling cycle to touch off each location.

things ive tried that dont work.

control definition>machine cycles>mill drill cycles - unchecked all and unchecked them off individually.

control definition>machine cycles>mill changed the height return options tried both options

control definition>machine cycles>subprograms> turned off "control supports subprograms"


any suggestions are welcome.

Thanks for your time.

Similar Threads: