Newbie Why can't I use one pass here?


Results 1 to 3 of 3

Thread: Why can't I use one pass here?

  1. #1
    Member inund8's Avatar
    Join Date
    Sep 2019
    Posts
    2
    Downloads
    0
    Uploads
    0

    Question Why can't I use one pass here?

    the part is ~.53" and I'm using a 1.0" bull end mill (r=.0315) but master cam tells me it can't do one pass because its not big enough?
    Any clues would be good thanks!

    ETA: the file is attached, as well as a picture of the issue

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Why can't I use one pass here?-one-pass-jpg  
    Attached Files Attached Files
    Last edited by inund8; 11-06-2019 at 08:41 PM.


  2. #2
    Flies Fast Superman's Avatar
    Join Date
    Dec 2008
    Location
    Antarctica
    Posts
    2802
    Downloads
    0
    Uploads
    0

    Default Re: Why can't I use one pass here?

    Turn on "Auto Angle" ... or set "Rough Angle" to 90° or 270° to machine the thinner section



  3. #3
    Member inund8's Avatar
    Join Date
    Sep 2019
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: Why can't I use one pass here?

    omagosh, thank you. The instructor gave us hard limit on our verify time, and you just saved me 10 seconds, and gave me the finish I want



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Why can't I use one pass here?

Why can't I use one pass here?

Why can't I use one pass here?