It's been about 10 years since I've used MasterCam.
I'm trying to create a machine origin at the corner of the stock and it's kicking my A$$!
Last software I used was CamWorks, no problem, pick the corner.
I'm wanting to use the lower left corner for XYZ zero. This must be a common practice but it's like a secret everywhere I look:
Re: How to set the origin at the corner of the stock?
Thanks for the reply. I ended up drawing a rectangle the size of the stock, at the bottom of the stock, creating a plane for that op, and locating the WCS on the corner, pretty much like you suggested.
Steve