2 x pi x radius
hello everyone
I am trying to see if mastercam can do this?
so I have a 10 inch O.D with a wall thickness of .250 so I.D is 9.5 inches
I am trying to see if I can unroll it (lay it flat) just trying to see how long of pcs of sheetmetal I have to cut?
hope that made some kind of sence? basically just trying to unroll a circle flat .
thank you
Similar Threads:
2 x pi x radius
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
You might need to visit a sheet metal forum for advice on where the neutral axis of a rolled cylinder is likely to be if the accuracy is really important. Its also going to take some fairly serious rollers to persuade 1/4 inch steel to assume the curve.
It's a bit more awkward than that
.... if rolling or bumping a sheet, the OD stretches & ID compresses...
roughly speaking, the mean sheet thickness is calculated for the bend
... so ... 9.75 x pi = 30.63" would be the cut length