You have to set the "Ref point" in each operation that you want the tool to be at either approaching, retracting, or both
The tool will start it's approach from the end of the last operation, not necessarily the tool change.
it is overcome by making sure the ref points chosen are betweem the machining area and the turret index position
OD turning or facing would be larger X than the turning stock, similarly ID turning would be to making sure the tool retract is only in the Z-axis, say Z10 absolute ( if the front face is Z0 )
the tool is outside the part it is not going to hit when going home
( my only suggestion would be to break up the retraction to the index position to going X-home & then going Z-home on seperate lines, that way, you only need to concentrate on getting any & all internal ops to be correct. )
Thanks Superman that's exactly what I was after, I don't know how I missed that greyed out ref points box, I must have clicked on just about everything else!
One more question, do you or anyone else know what the post variable is for the inner dimension of the stock. I can post all the other stock dimensions.