Fanuc manual guide

[Chip]

Hello
I started to work for a firm that mainly deals with controller Fanuc 18i at turning machines.
I have only worked as a milling operator at Heidenhain. So I’m crossing borders into new frontiers twice: Fanuc and turning.

About 1500€ for Fanuc software with purpose of home exercising is too much for me.
Are there any alternatives or demo versions like those by Heidenhain?

Thanks in advance

[InTex]

Hello

I would say 1500€ is cheap.
I can’t offer you anything for the 18th controller. Only for Fanuc Series 21.
But it’s in DIN.
Can be downloaded at Emco.at.

Regards, InTex