- 3 phase motor from Cincinatti #2 Tool and cutter grinder not working
-
Member
3 phase motor from Cincinatti #2 Tool and cutter grinder not working
Hello Everyone,
I purchased a Cincinatti #2 Tool and Cutter Grinder on Ebay and have just hooked
it up...nothing.
I checked first to determine that it was wired for Low Voltage 220 3 phase
I am getting power to the motor as 206 volts to each leg. I live in Mexico so thats all we get here.
I disconnected all 9 motor leads and checked the conductivity of each possible combination
of leads 45 in total.
8 of these combinations are closed and I believe that only 6 should be closed.
Can anyone verify this or give me another test to determine if this Spindly Motor will
need to be rewound?
Best Regards,
Preston
Similar Threads:
-
-
Member
Re: 3 phase motor from Cincinatti #2 Tool and cutter grinder not working
Ok, found the problem...
2-8 is open vs 1-4 and 3-6 have 7.1 ohms resistance.
Best Regards,
Preston
- 3 phase motor from Cincinatti #2 Tool and cutter grinder not working
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules