jitter problem

Results 1 to 1 of 1

Thread: jitter problem

  1. #1
    Registered
    Join Date
    Mar 2016
    Location
    United States
    Posts
    12
    Downloads
    0
    Uploads
    0

    Default jitter problem

    I hope this is in the correct area. If not, please move as needed. I am trying to run down an issue with what I will refer to as jitter along a straight line. I am not sure if it is electrical interference or some other issue. Please see the attached picture to get an idea of what I am talking about. The line in question is along the X axis. I have the chassis all grounded and the cable going to the spindle is connected using double shielded cable and is also in a grounded flex conduit. All connections are tight as far as I can tell.



    Similar Threads:
    Attached Thumbnails Attached Thumbnails jitter problem-fullsizeoutput_1599-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

jitter problem

jitter problem