Need Help

[Thorfaust]

Hi,
is there a possibility to tell MadCam only to cut a special part of my raw part ?
I only want the 2 areas on the left and right side to be cutted and the Block in the middle not. I dont find a proper solution for this.
See the picture attached.
Maybe someone has an idea !?

[JerryBradley]

Hi,
is there a possibility to tell MadCam only to cut a special part of my raw part ?
I only want the 2 areas on the left and right side to be cutted and the Block in the middle not. I dont find a proper solution for this.
See the picture attached.
Maybe someone has an idea !?

Outline the region that you want to machine by drawing a box or curve around it. Then select the curve to define a region by selecting the closed curve icon under the yellow box icon (third from the left). Then hit return. Machining will then be only within the selected region. You can read about Region Curves in Help under Regions. Hope this helps.