- Problem- Toolpaths don't simulate if they are in a group
-
Member
Toolpaths don't simulate if they are in a group
If I make a group of the toolpaths in a part, they don't simulate until they are ungrouped. I don't know if this is expected behavior or not.
Similar Threads:
-
-
Member
Re: Toolpaths don't simulate if they are in a group
Grouping toolpath groups will cause problems because the toolpath curves that belongs to each toolpath operation is grouped in Rhino by madCAM. When you recalculate, simulate or post process, madCAM will loop through all groups in Rhino and detect if it's a toolpath group created by madCAM. If grouping toolpath groups, they will not be detected as toolpaths anymore. This can be solved just by ungrouping so it only will be one group for each toolpath operation.
The toolpath order is controlled by the Rhino layer order. At the moment, it isn't possible to control the toolpath order by grouping toolpath groups, but we will see what we can do about this to make this possible in a future release of madCAM 7.
- Problem- Toolpaths don't simulate if they are in a group
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules