- Problem- Ball end toolpath is shown as a radius above the model?
-
Member
Ball end toolpath is shown as a radius above the model?
When I make a toolpath with a ball end cutter, the toolpath is drawn at a height above the model which is the radius of the cutter. The toolpath with a flat end cutter is what I would expect - it is on the model.
If the top clipping plane is below the radius of the cutter, nothing is cut. What I expect is that the toolpath would be drawn as the bottom tip of the cutter and this would be what the clipping plane would be associated with.
Similar Threads:
-
- Problem- Ball end toolpath is shown as a radius above the model?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules