- Remachining - 2 problems
-
Member
Remachining - 2 problems
1. The area covered by planar re-machining changes depending on which direction is chosen. I don't understand why the region that is re-machined should depend on the cutter direction during the machining.
2. Planar re-machining misses areas. There are planar areas which are not cut by either the previous cutter or the re-machining cutter.
Similar Threads:
-
- Remachining - 2 problems
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules