- Rapid height is too high
-
Member
Rapid height is too high
I am profiling a curve but the rapid height is way too high and doesn't correspond to my SafeClearance setting. Is there something else I should check? The clearance heights for other operations (z-level, planar) are fine and what I would expect.
Similar Threads:
-
-
Member
Re: Rapid height is too high
I too occasionally have this problem and regenerate once it twice usually fixes it, though it is inconvenient when you only realise it after when you go to run the part.
Sent from my Pixel 3 using Tapatalk
-
Member
Re: Rapid height is too high
Regenerating multiple times didn't work for me. This also happens on a trivial test part.
- Rapid height is too high
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules