- Need Help!- 4th axis is not rotating continuously
-
Member
4th axis is not rotating continuously
Hi
I need help in writing a post for my 4th axis indexing table (Chuck). I am programming in Unigraphics NX8 and tried the generic 4th axis UG post. But the 4th axis is trying to go back to zero before start rotating again. Is there any thing I can change in my post to make the 4th axis run continuously without going back to zero again after each rotation of 360 deg. Can any one send me an example of the post. My 4th axis is set parallel to X axis.
Any help in this matter will be much appreciated.
Thanks
Parm
Similar Threads:
-
-
Member
-
Member
Re: 4th axis is not rotating continuously
Thank you Mauri
but I am looking the post processor setting in Unigraphics NX8
-
Flies Fast
Re: 4th axis is not rotating continuously
This may be a machine setting....try programming different scenarios to get the machine correct before modifying your CAM
-
Member
- Need Help!- 4th axis is not rotating continuously
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules